New Posts  All Forums:Forum Nav:

Wiring?

post #1 of 5
7/28/03 at 9:04pm
Thread Starter 
Okay, this may seem as a dumb question, but what wires do you use for wiring in your amp? And more importantly, where'd you get them from?

Thanks.
Reply
post #2 of 5
7/28/03 at 9:15pm
I am using the Belden Teflon coated wire. You can buy it by the foot at handmades website at: http://www.hndme.com/storebeldenwire.html
Reply
post #3 of 5
2/19/12 at 12:43pm
Quote:
Originally Posted by tbdoah View Post

Okay, this may seem as a dumb question, but what wires do you use for wiring in your amp? And more importantly, where'd you get them from?

Thanks.


Everything I use for hookup wire is 22ga teflon spc from John's Silver Teflon Wire Shop on ebay (Navships).  It's been over 6 years with using his wire and I would highly recommend him.
 

 

Reply
post #4 of 5
2/20/12 at 6:33am

Same as TomB, but 24ga. For signal I will occasionally use Neotech UP-OCC as well.

Reply
post #5 of 5
2/20/12 at 7:45am

 

Quote:
Originally Posted by Pars View Post

For signal I will occasionally use Neotech UP-OCC as well.

 

Agreed with Pars, the Neotech UP-OCC (in PTFE) is great for internal hookup. I also like Kimber TCSS, which is copper in PTFE (Teflon). It's a thicker 19 gauge wire so it's good for wiring up point-to-point tube amps. Both are available at PartsConnexion. Handmade and Angela Instruments also carry the Kimber. 

Reply
New Posts  All Forums:Forum Nav:
  Return Home