New Posts  All Forums:Forum Nav:

bithead dac help

post #1 of 5
10/30/08 at 5:32pm
Thread Starter 
Hi,

I'm using a Bithead for 3 or more years now. Together with my ipod, it serves its purpose well with no problems whatsoever. But whenever I hook it up with my laptop via USB cable, I dont hear any difference whether Bithead's switch is off (amplification only) and switch is on (amp + dac). Im thinking maybe because of the quality of the soundcard is equal to the quality of Bithead's dac? Is this the case?
Does an upgrade to say a HR portable micro w/dac yield any significant change?

BTW, im using iTunes on XPS M1530.

Thanks for any response.
Reply
post #2 of 5
10/30/08 at 6:36pm
Quote:
Originally Posted by pleco00 View Post
whenever I hook it up with my laptop via USB cable, I dont hear any difference whether Bithead's switch is off (amplification only) and switch is on (amp + dac).
With a USB connection turning on and off the power switch just changes the analog ouput section of the BitHead to either run on the BitHeads batteries (on) or to run off the power that comes from the computer up the USB cable (off). If you hear no difference it's because your computers power is fairly clean, and/or also because you are not driving headphones that are hard to drive.

Basically you can get a little more voltage out of the batteries so the BitHead will put out a louder signal before clipping if running on batts instead of computer power. But if you're listening with relatively efficient headphones you won't hear much difference.

However, in either case you are listening to the BitHeads amp not the computers.
Reply
post #3 of 5
10/31/08 at 12:55am
I just sold my Bithead and using it with my Grado SR-60s and my Powerbook G4, I didn't hear all that much of a difference, slightly less noise if anything. With my K601s, though, the difference was more noticeable.

Also, I actually never thought about the power switch when I had it connected to my computer. I assumed it was running the amp and the DAC through the USB.
Reply
post #4 of 5
10/31/08 at 1:17am
I have had the bithead for a little while, and found that it sound just a tiny bit cleaner with the switch on.

Tyll explained it all, you are running from the Bithead's internal DAC whether the switch is on or off. That's why.
Reply
post #5 of 5
10/31/08 at 2:14am
Thread Starter 
hmmm, now I get it

Thanks folks!
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: HeadRoom Premier Sponsor Forum