Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › how is double regulated power supply?
New Posts  All Forums:Forum Nav:

how is double regulated power supply?

post #1 of 6
Thread Starter 
I just saw an example of preregulated power suppy in TI's LM317 datasheet.
Anyone tried that?
What's the benefit of that?
post #2 of 6
Hi,

Are you talking about tracking preregulator?

T
post #3 of 6
Thread Starter 
post #4 of 6
Not quite sure. See this.
More efficient power supply.

http://epaper.kek.jp/p99/PAPERS/FRA170.PDF
post #5 of 6
A tracking pre-regulator, as in fig5. of the National Semiconductor datasheet, is used mostly to split the dissipation up between the two regulator ICs. Whatever improvement in line or load regulation that results is likely to be offset by the poorer stability of two high negative feedback control regimes in series (ie - the two regulators, that is).

The other pre-regulator circuit mentioned by jasonhanjk utilizes a switchmode power supply ahead of the linear regulator to reduce the linear regulator's dissipation while preserving its superior transient response and without too much of in increase in noise (some noise from the switching regulator will inevitably slip past the linear regulator). Since most op-amps exhibit exceptionally high power supply rejection ratios, even well beyond 20kHz, it really is doubtful that a regulated supply, much less a pre-regulated supply, is worth implementing!
post #6 of 6
Hey,

Just for record, LM317 regulators are pretty good as is. I keep using them because it is very easy to build and to use and you can get very good performance. You will probably find that you can barely hear any difference especially when you are using opamps.

I would pay more closer attention to passive components that surrounds the regulators.

T
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › how is double regulated power supply?