Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Quick CK2III question
New Posts  All Forums:Forum Nav:

Quick CK2III question

post #1 of 6
8/29/08 at 11:35pm
Thread Starter 
quick question does VR1 & VR2 need some isolation pads between the bare metal contacts and the heatsink?

Thanks.
Reply
post #2 of 6
8/29/08 at 11:42pm
Look at the board, the heatsinks are not connected to anything so no, you don't need to isolate them. You do want to use heatsink compound or a heatsink thermal pad though.
Reply
post #3 of 6
8/29/08 at 11:43pm
No just use some thermal past and you'll be good.
Reply
post #4 of 6
8/29/08 at 11:43pm
got beat by seconds!
Reply
post #5 of 6
8/30/08 at 12:01am
Thread Starter 
Thank you!
Reply
post #6 of 6
9/20/11 at 1:53pm

I would have another CK2III question.

 

I build this amp and like it very much, if .... if it is warm already. In the first hour it does not sound good. This is very annoying for me. I do not want to leave it on, but can not wait one hour either. 5-10min would be O.K.

 

Do you have experience to build on a really large heatsink ? I'm thinking about to put it into an enclosure which is a big heatsink. I suspect, the working temperature will be much lower, so bias current will be close on the just switched on amp to a running for a day amp. I suspect the bias current is what makes the difference. That settles very slow.

 

Another way would be, to use no heatsing, so transistors heats up quick. There is problem with this, I like it on high bias current.

 

?

 

Thanks,

JG

Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Quick CK2III question