Head-Fi.org › Forums › Equipment Forums › Portable Headphones, Earphones and In-Ear Monitors › Sennheiser CX500 Cord Winder - How to use it?!?!
New Posts  All Forums:Forum Nav:

Sennheiser CX500 Cord Winder - How to use it?!?!

post #1 of 7
Thread Starter 
I got today the Sennheiser's CX500 - I am pretty happy with them so far.

No matter which way I tried I just can't figure how to use the included cable winder. I understand that the earphones should go in the holes but how deep? and then, what to do with the cable? how do the cable goes in the two notches on each side?

I searched all over the net and I couldn't find a video or pics showing how to use it. Can anybody help? Can anyone upload some step by step pics?

Thanks everybody!
post #2 of 7
push the earbuds into each socket. then, wrap the cable around the flat extension. put the excess cable closest to the jack into the slot with a slit in it.
post #3 of 7
cheers i had the same annoying issue. In that case, what is the hole at the other end of the winder for?
post #4 of 7
can i please have a picture of what it looks like when its wrapped up, mine doesnt look right
post #5 of 7

How to use the Sennheiser cable winder

Here are the photos of how I believe this cable winder should be used:

This one shows how to shorten the cable (that's what the other hole is for):
Attachment 28786

And this one shows how to completely wind the cable:
Attachment 28787
LL
LL
post #6 of 7
Thanks for the answer !
post #7 of 7

Would you be shortening the life of the cord by winding up the wire?

 

I mean, it does seem like there is some stress going on when it is wrapped around the wad of rubber...

New Posts  All Forums:Forum Nav:
Head-Fi.org › Forums › Equipment Forums › Portable Headphones, Earphones and In-Ear Monitors › Sennheiser CX500 Cord Winder - How to use it?!?!