New Posts  All Forums:Forum Nav:

Jambo DAC - Page 15

post #211 of 215
1/20/11 at 6:22am
Thread Starter 

Hi Subbu,

 

Glad to hear some interest.

 

You'll need a parallel LCD with HD44780 driver. I've set it up to use 4 bit parallel mode as I didn't have enough spare pins for anything else.

 

Pretty busy just now but I'll get the code to you when I have time and also a schematic.

 

Regards

 

Jamie

Reply
post #212 of 215
1/28/11 at 10:10pm

I found an official pdf that lists all the sampling frequencies from S/PDIF.

 

 

http://tech.ebu.ch/docs/tech/tech3250.pdf

Reply
post #213 of 215
4/28/11 at 8:39pm

Hi Jamie,

 

Could you post the schematic and the code when you get some free time? 

 

Regards

Subbu

 

Reply
post #214 of 215
9/12/11 at 5:14am
Thread Starter 

Hi Folks,

 

Home again - so if anyone wants a kit please let me know this week.

 

Subbu,

 

Sorry for the delay. Please find the pinout below - but crosscheck it with the particular HD44780 LCD that you get, the below is quite standard but not 100% in my limited experience. I've noticed that Pin3 on the LCD varies a bit. From memory I think Pin3 and Pin15 can be used to vary the contrast and brightness.

 

LCD Pin Description Board Pin Micro Pin
1 GND    
2 +5V    
3 GND    
4 Register Select SW3 13 (PB1)
5 R/W SW5 14 (PB2)
6 Enable SW7 15 (PB3)
7 NC    
8 NC    
9 NC    
10 NC    
11 DB4 LED1 16 (PB4)
12 DB5 LED3 17 (PB5)
13 DB6 LED5 18 (PB6)
14 DB7 LED7 19 (PB7)
15 +5V (    
16 GND    
  Source Select SW SW1 12 (PB0)

 

Code/hex to follow!

 

Cheers

 

Jamie

 

Reply
post #215 of 215
9/18/11 at 11:59pm

Hi Jamie,

 

Thanks for the pinout. Let me know once you have the new code/hex ready. 

 

Cheers...

Subbu

 

Reply
New Posts  All Forums:Forum Nav:
  Return Home