New Posts  All Forums:Forum Nav:

WTB: Help repairing op-amp solder pads on an X-Fi Elite Pro

post #1 of 2
1/6/08 at 1:03am
Thread Starter 

I'm looking for someone who can repair/bypass smt solder pads on a PCB. I've swapped out soic op-amps on several X-Fi's in the past without incident, but on this particular card I wasn't careful and rushed, popping off 6-8 solder pads (top two op-amp mounts, bottom two are fine).

I'll give whoever fixes the card a Xenos 0HA-REP amp, or money if preferred (I can do cash, paypal, and USPS money orders).
Reply
post #2 of 2
1/6/08 at 6:35pm
Thread Starter 
Close up of the section in question (I tried using a circuit writer pen, but it was too old to hold up well when I soldered the op-amps on. Comes right off with acetone/nail polish remover) Original 4mb closeup picture here.
Reply
New Posts  All Forums:Forum Nav:
  Return Home