The Apple diyMod: My Take on the Famous iMod [56k killer] Featuring 3G, 4G, 5G and nano 1G! - Page 41

+ adding a superb line in for decent recordings, that would be the ipod i want

Have anyone see Xin's supermicro? it runs off a 1.5v AAA battery, and will most likely be able to fit inside the case of the stock ipod. might be a good amp to be placed inside, and from I heard, it sounds pretty good for something that small

hey all, i'm sure this has been asked before but....


I have a 4th gen ipod.


I removed the Z caps off the PCB board (C84/C86) and soldered down 2 wires respectively.

I want to connect the newly soldered wires to the headphone jack of the ipod.


I inserted a 3.5mm mini plug into the headphone jack, I used a DMM to figure out which is left/right, but for some reason both channels and the ground show continuity??

edit: i do not understand why there is continuity, shouldn't the channels be seperated

Is something wrong with my ipod jack?

Can someone circle which should be the L/R/Gnd channels?




thanks

shouldnt the left channel be closer to the bottom?

In theory Yes, in this jack No

I got tired of charging, playing, charging, playing, etc to burn-in my caps for the diyMod Nano. It would take forever to burn-in at this rate. I decided to make a dock similar to KokoKrunch's to play and charge at the same time, but I did not want a long usb cable attached to it.

So I decided to attach a female USB connector to it instead. I got lucky and remembered that the dollar store close to my Uni has female to male USB cables for $1. I took one female end for the iPod dock, and soldered the two male ends together.

It took me quite a few hours to get everything working. Here are a few hints:

1) BUY USB 2.0 cables (i.e. not from the dollar store). Initially the iPod would not charge or get detected, but you can tell something is going on since the screen goes bright as you charge it. In my linux box, it threw a bunch of errors. A quick google shows that some USB 2.0 devices do NOT work with low-quality cables (the one I bought and most USB 1.1 cables). I will spare the details on how I got it working.

2) Open iTunes, go to the summary of the iPod, check "manually manage music".

3) The iPod will have the standard "do not disconnect screen". Just eject it through iTunes and it should charge and play at the same time.

Pictures:

nice, now we know that the right pins for those...you do that at the school Christine ?

I do my best DIY work when I'm supposed to have a lot of stuff to study. LOL

Naturally I couldnt go over this whole thread. Forgive me if this has already been mentioned but how does this DIY iMod compare to the RedWineAudio iMod?
Also I would like to know if any of the succesful DIY iModders here are willing to mod it for me?

Haha, Cavanessia's dock is opposite of mine, mine has 3.5mm input jack and USB out. and the USB comes out from the side. Anyways, moriez, I would say... no difference.

Wow, I just saw this thread. Very helpful information.

Too bad it wasn't around when I did this to my 4g, 4g photo and 5g ipods

You don't know how hard it was to find information on how to properly do this. Lucky I found about 2 threads which were helpful enough and one member made a website which helped too.

I don't get how they were about the same thing (but only 4g models), and they didn't reach past page 2- i believe.

Also, i'm not 100% sure, but I even believe one member got ban/post deleted, for doing a DIY imod and releasing the information on it. It's hard to remember being so long ago, but he was ban for something along those lines and made a new account declaring it.