Cardas Myrtle Wood Blocks

i just ordered some cardas myrtle wood blocks to use as resonance/vibration control for my G08. i wanted to try something for it and had read pretty decent reviews about these blocks. they were only around $45, so i did not think the risk was too great. if they do something positive to the sound, great. if not, no big deal.

does anyone have any experience with them.

thanks

those are the ones. they come in 2 sizes, large and small. i got the larger ones. why not. only a little more. they give you six blocks, which you can use for two components in pyramid formation. i am only going to use it with my G08, at least initially, so i will use four in a square and set the other two aside.

what is the cardas logo a picture of anyway and what is the rationale behind it, if anyone knows.

from that link:

that's cool. i think that is right. even if the blocks don't work or work to my liking, i'll have some nice decorations.

got the cardas blocks today. the 6 wooden blocks come in a nice velvet-type pouch. they come in two sizes, small and large. i got the large blocks. but even they are kind of small. each block measures 1" x 1.618" x 2.618". very nice looking wood with some type of lacquer finish and of course each block has that cool-looking cardas logo on it - whatever it may be.

my current setup sits on a very large - think oversized - wooden end table. the G08 rests on the table with nothing underneath. on top of the G08 is a thin yet sturdy piece of oak wood, then the apache power supply and then the apache amp. the apache power supply and amp each have four still points for vibration/resonance control. i read that the most typical configuration was to use 3 blocks in the shape of a pyramid with 2 in the back and 1 in the front. this is also convenient as 6 blocks allows for use with two components. my only intention was to use them under my G08 player, so i planned to use 4 - one at each corner.

the G08 is heavy and the stuff on top of it is not terribly light. it took me a while to set everything up - to get the 4 blocks under the four corners of the player. also, i realized as i was trying to situate the blocks that the bottom of the G08 is not entirely flat. at each corner, there are smallish rubber pads - so the blocks did not sit entirely flush at the corners. but they seemed good enough. before i set up the blocks i listened to a a few tracks of a CD i am familiar with. i listened again with the blocks. could not detect any difference. went back and forth a while - blocks, no blocks; 3 blocks, 4 blocks; blocks at corners or closer to middle. after about 1.5 hours, i concluded that if there were any differences, i could not detect them.

next tried 3 or 4 blocks under the amp portion. no change. final test. 4 blocks under the power supply instead of the still points. 1st track. omg! what happened. very noticeable increase in sound stage and imaging - not subtle. removed the blocks. everything got a bit smaller. put the blocks back. larger. why they did nothing under the CD player or amp, i don't know, but under the power supply. yes. they work. i guess you just have to play around with them for a while.

edit: 3 or 4 blocks under the power supply seem to have the same effect, so i'm going with 3 under the power supply and 3 under the amp portion - 2 in the back and 1 front center. definitely worth the $40+ or so i spent.