Head-Fi.org › Forums › Equipment Forums › Cables, Power, Tweaks, Speakers, Accessories (DBT-Free Forum) › necessary to replace speaker cables?
New Posts  All Forums:Forum Nav:

necessary to replace speaker cables?

post #1 of 3
8/27/07 at 9:31pm
Thread Starter 
I currently have an Onkyo TX-SR575 receiver that I'm going to be connecting with the speakers from the Cambridge Soundworks DTT2500 computer set. I'm also using the wires that were supplied with this speaker set so I'm wondering if it would make any sense to replace them or if I should wait until I get some real speakers?

After scouring the net I believe the speakers are 4 ohms and the cables look to be in the 20+ gauge...
Reply
post #2 of 3
8/27/07 at 10:54pm
unless you are doing 50+ foot runs with your speaker cable, 20 gauge is fine
Reply
post #3 of 3
8/28/07 at 1:22am
I'm not into cables in any sense of the word, but the last set of Cambridge's I had came with some pretty flimsy wire. Some lamp cord or speaker-wire on a roll would probably serve you well for under $10.
Reply
New Posts  All Forums:Forum Nav:
  Return Home
Head-Fi.org › Forums › Equipment Forums › Cables, Power, Tweaks, Speakers, Accessories (DBT-Free Forum) › necessary to replace speaker cables?