Did up two of these for my iems tonight they took under 10 minutes each. Most of the time was prepping the measurements with strips of green painter's masking tape marked for alignment.
These are 21 cm by 15 cm ACRYLIC ( not glass ) display frames that have a secondary face attached by 4 magnets at each corner for throwing pictures inside. Strong enough they do not come apart without a pull.
Methyl Chloride liquid applied with a needle applicator bottle to melt the hooks in place. Applied to the hook bases then pressed on while the face was horizontal. Easy that way and avoids any stray drips if you are careful.
I wanted a more condensed stand than the wood iem one I had made from fir and maple.
Can hold 2 iems per hook, obviously if wrapped properly in a smallish loop.
I was at the Industrial plastics store today and in their bins they had some insanely heavy and thick chunks of Acrylic sheet off-cuts, but this was easier than cutting and cheaper too.
something fun anyone can do fast.
Edited by nick n - 9/19/15 at 12:06am