DIY Headphone Stand
This was a about $1.00 cost project for me...items have been in the garage for years.
!!! Nothing is too good for my refurbished Shure SRH440 headphones from Ebay ('sock mod' completed upon arrival) !!!
Glue (Permatex Clear Silicone Adhesive Sealant)
Spray Paint - Flat Black
1" Diameter Wooden Dowel or PVC Pipe
1/2" Felt strip (it is sticky on one side)
Aquarium Rocks or Pea Gravel or Marbles
Swim Noodle (3.75" outer diameter / 1" inner diameter)
1 - 6" x 6" Ceramic Tile from the flooring department of Lowes ($0.88) This was the only thing I had to buy...already had all of the rest
Small Serrated Knife
You can drink the wine at any time...before or during the project...rinse the bottle and let it dry.
 Cut a one foot length off of the end of a swim noodle.
 Cut a one foot length of 1" dowel and insert it through the middle length of swim noodle.
 Spray the one foot segment of the swim noodle/dowel with paint and allow it to dry.
 Put a strip of felt along the bottom edges of the ceramic tile.
 Fill about one-third of the wine bottle with aquarium rocks, or pea gravel, or marbles (use funnel). Be sure to put the lid on the wine bottle to prevent glue from dripping inside.
 Cut a hole, slightly smaller than the outer diameter of the top of the wine bottle, 6" from the end of the swim noodle, until you hit the dowel, which is inside of the swim noodle.
 Pour some glue into the hole and twist the wine bottle (with lid attached) into the hole.
 Put glue around the bottom edge of the wine bottle and center it on the ceramic tile.
 Let it dry...be patient!
 Hang up your headphones!
*** If you have very heavy/large cans, you could use two wine bottles and a longer section of swim noodle. ***
This was a fun project, wandering around the house and garage, thinking "what can I hang my headphones on?"
I'm not skilled/talented like some of you...just a mom!
Tweaked and edited...here are a couple of pics with the ceramic tile base.
Edited by cdeviney - 6/29/13 at 1:53pm