New Posts  All Forums:Forum Nav:

Headphone stand

post #1 of 23
Thread Starter 
Has anyone seen this anywhere around:



http://www.audio-technica.co.jp/prod...at-hps500.html
post #2 of 23
WOW...nice find.
post #3 of 23
Thread Starter 



Interestingly the AT-L3000 does not fit as well as the others. Source site is Careless Headphone.
post #4 of 23
Nice! So clean.
post #5 of 23
Will be hard to find here since it just came out 2 days ago in Japan; still emailed Pricejapan
post #6 of 23
Thread Starter 
Request for Quote already sent...
post #7 of 23
For the ATs I'd use a stand that doesn't compress the pads at the bottom. IE something where the pads are free floating and only come in contact with each other.

With the L3000 pads I've found the foam underneath the leather stays compressed in certain spots for a long time before it reforms.
post #8 of 23
I noticed that the W5000s are pivoted more than the L3000s and compresses easily on the WooAudio stand. The AT stand here should be perfect for the L3000s.
post #9 of 23
Thread Starter 
Quote:
Originally Posted by 2deadeyes View Post
I noticed that the W5000s are pivoted more than the L3000s and compresses easily on the WooAudio stand. The AT stand here should be perfect for the L3000s.
Actually the L3000 was shown as not being a good fit with this stand and a warning was given on Careless about this issue.
post #10 of 23
If you have no luck finding it, it would be easy to reproduce, and that is a nice slick design.
post #11 of 23
Quote:
Originally Posted by swt61 View Post
If you have no luck finding it, it would be easy to reproduce, and that is a nice slick design.
I was thinking the same thing. Do you think that's lucite? Or is it actually glass?
post #12 of 23
Probably glass. Either would work fine, but glass will hold up better without scratching.
post #13 of 23
I will apply for a patent pretty soon to avoid any misunderstandings, no doubt that glass look terrific, still need to improve the top part, but for now working in a 1/2" glass one, this one is 3/8" glass:

post #14 of 23
Nicely done Sovkiller =)
E base don't give me much confident thou.. maybe can get someting sturdier?. but nice classy design
post #15 of 23
hmmmm that stand may work very well with stax earspeakers\

the brown leathery colour of my sr-404s look mighty fine on a silver woo audio stand, my only gripes are that at the top because the woo audio stand is fairly thin where it makes contact with the headband, it compresses the faux leather cushion, and leaves an indent for a while after removing, so something that is a but more wider and rounded out would be ideal (atm using a sticky tape roll to distribute the load more evenly)

and the second is that it's an incy bit too low, and the cables press against the bottom of the stand a bit too much for my liking, so... know the sheer size of AT phones this may be the perfect solution
New Posts  All Forums:Forum Nav: