Head-Fi.org › Forums › Equipment Forums › Headphones (full-size) › Where can I get a shirt clip for my IEM's?
New Posts  All Forums:Forum Nav:

Where can I get a shirt clip for my IEM's?

post #1 of 8
5/31/07 at 10:59pm
Thread Starter 
I use UM2's on stage and I need a shirt clip. Where can I buy one? The only people I see selling them are Etymotics. How strange! Sould those work on mine? I assume they would cause all it does is hold a cable but I want to be sure.

Reply
post #2 of 8
5/31/07 at 11:15pm
The Etymotic one (well, the one for the ER-4) holds onto the pod of the ER-4's, so no, it wouldn't grab onto the cable(s). I don't know about the one for the ER-6(i)'s, though.
Reply
post #3 of 8
6/1/07 at 4:03am
Easiest source is on the shirt clips for mobile phone hands free kits. I'd wager you have a few phones lying around (everybody does by now), and a few unused hands free kits, they'll just clip onto the wire and solve your problem.
Reply
post #4 of 8
6/1/07 at 4:14am
rat shack
Reply
post #5 of 8
6/1/07 at 7:31am
I use a small plastic coated paper clip. The inner curve fits snugly around the base of the y-joint, I then bend the outer curve perpendicular to the inner curve and clamp it to my collar. I've been using the same one for 2-3 months with no ill effects.

Team Ghetto Clip
Reply
post #6 of 8
6/1/07 at 10:35am
i use a small binder clip, loop the cable thru 2x. Looks stupid, but you get 3 dozen for $3 at office depot.
Reply
post #7 of 8
6/1/07 at 11:17am
Dollar store cell phone hands-free mic clip. You might have to dig around a bit, since most of the clips are too small for the cable.
Reply
post #8 of 8
6/1/07 at 3:41pm
I ordered a couple of these Plantronics clips linked below for my UM2. Bought two in case I lose one, came to about $15 shipped. I only connect the clip when I actually need it, leaving it connected 24/7 could eventually damage the cable (due to the "clamp" pressure). I connect it to the clear tubing right after the "Y" connector goes from 2-to-1 (not directly on the twisted cable).

http://www.twacomm.com/catalog/model...oogle&ovtac=PI

BTW, I got the idea from Sgt Strider this thread:

http://www.head-fi.org/forums/showthread.php?t=135821
Reply
New Posts  All Forums:Forum Nav:
  Return Home
  Back to Forum: Headphones (full-size)
Head-Fi.org › Forums › Equipment Forums › Headphones (full-size) › Where can I get a shirt clip for my IEM's?