New Posts  All Forums:Forum Nav:

Small speaker amp required

post #1 of 29
Thread Starter 
Having just scored a pair of JBL E20s off ebay for $27 I think some form of amplification is called for. I do have an old NIKKO TRM20 but that is a modest 12wpc and I suspect I will really need a 20wpc minimum to drive the JBLs.

However the amp must be shelf mounted and my shelves are pretty small i.e the amp absolutely cannot be more than 10" deep, which is a somewhat limiting factor. And of course since this is a office system I want to do this on the cheap i.e under $100 if at all possible, so I am scouring eBay again.

Does anybody know of any compact amps (of any vintage) that are of the small persuasion and can deliver 20wpc into 8ohms.

Thanks in advance
post #2 of 29
The Parasound Zamp is half-rack width. I have one driving my Totem Mites. Highly recommended.
post #3 of 29
Thread Starter 
Quote:
Originally Posted by gregeas View Post
The Parasound Zamp is half-rack width. I have one driving my Totem Mites. Highly recommended.
It looks very nice but I am really looking for something more modest, it is just for a Creative Zen..............Small Bookshelf Speakers system.
post #4 of 29
Quote:
Originally Posted by hciman77 View Post
It looks very nice but I am really looking for something more modest, it is just for a Creative Zen..............Small Bookshelf Speakers system.
I would think that you could get fine volume from them with your current amp, and probably sound fine too. Iv found that vintage watts are alot more potent than newer stuff. IE: "700 watt" recievers only rated on the back for 500 watts of max draw... Over 100% efficency, its amazing
post #5 of 29
Thread Starter 
Quote:
Originally Posted by phergus_25 View Post
I would think that you could get fine volume from them with your current amp, and probably sound fine too. Iv found that vintage watts are alot more potent than newer stuff. IE: "700 watt" recievers only rated on the back for 500 watts of max draw... Over 100% efficency, its amazing
Thanks for that, I will give it a shot first, I am replacing an old Sony MiniSystem which I use to amplify the Zen, the Sony is rated at 15wpc rms into 4 ohms but the output from my Zen is so low that it is sometimes necessary to have it on full to drive its own (Sony) 4ohm speakers. And the output from my iPod which I connect in sometimes is even lower.

Given that I will be driving 8 ohm speakers I was concerned that 12wpc would not be enough.

But I will give it a shot first.

Cheers
post #6 of 29
post #7 of 29
Thread Starter 
Quote:
Originally Posted by rsaavedra View Post
The problem is that the output level from my DAPs is quite low and from the performance tests I have seen the T-Amp can only deliver 5 - 6 watts into 8 ohms before its distortion level curve goes almost vertical, and the distortion is at ~ 10% by the time you hit 10 watts. So it would be a bit of a gamble.
post #8 of 29
I believe there is a newer version called the Super T Amp.
post #9 of 29
Quote:
Originally Posted by mrarroyo View Post
I believe there is a newer version called the Super T Amp.
Didn't know about that one. Searched for it and found this link with measurements for both. Actually I don't like the measurements too much on either one. It seems they would tend to be bright. Between 10kHz and 20 kHz they have 1dB+ increased freq. response driving 8 Ohms loads. Didn't know about this.
post #10 of 29
wow, pretty clearcut answer.

solution : trends audio ta10.1 t-amp! the hot-rodded version of the super t-amp!
check it: http://www.6moons.com/audioreviews/trends/ta10.html

I've been pretty tempted to spring for it myself! ah..maybe a coupla months down the line...
post #11 of 29
Shootout - the trends wins, although i'm not sure what that means.

http://www.stereomojo.com/SHOOTOUT2007INTEGRATEDS.htm
post #12 of 29
Quote:
Originally Posted by ooheadsoo View Post
Shootout - the trends wins, although i'm not sure what that means.

http://www.stereomojo.com/SHOOTOUT2007INTEGRATEDS.htm
Now, WHY oh WHY did you have to show me that link? My trigger finger itches
post #13 of 29
The 100W version of the T-amp fits your bill. It's no bigger than the T-amp with power supply included. And it's cheap!
post #14 of 29
Thread Starter 
Quote:
Originally Posted by cotdt View Post
The 100W version of the T-amp fits your bill. It's no bigger than the T-amp with power supply included. And it's cheap!
Have you got a link for that ?
post #15 of 29
Quote:
Originally Posted by hciman77 View Post
Have you got a link for that ?
At diykits.com.hk, they sell the Little Dot T-Amp. Mine is this one called the AMP5:

http://41hz.com/

Here is another one:
http://www.audiodigit.com/index.php?section=26
New Posts  All Forums:Forum Nav: