Well, I read a page in the Headphone Forum about wanting to know how to and what the effects of recabling KSC-75s is, so I took and finally recabled mine.
I uesed Neutrik mini connector -> 4 runs of 26 ga SCC -> tech flex covered -> ends clear heat shrink covered.
My initial impression was that solderign to the contact points on the phone was going to be a pain. However, when I opened it the points were alot bigger than I expected, so that ended up being about the quickest part of the operation.
SOUND:
I can notice a slight increse in detail, and oddly enough It seems that I am getting alittle tighter bass response. THe detail is still not up to the level of my A250s, but I'm greatly enjoying these "new" phones.
Just for the intrested, I haev Kramer modded and wuarter modded these.


-greg
I uesed Neutrik mini connector -> 4 runs of 26 ga SCC -> tech flex covered -> ends clear heat shrink covered.
My initial impression was that solderign to the contact points on the phone was going to be a pain. However, when I opened it the points were alot bigger than I expected, so that ended up being about the quickest part of the operation.
SOUND:
I can notice a slight increse in detail, and oddly enough It seems that I am getting alittle tighter bass response. THe detail is still not up to the level of my A250s, but I'm greatly enjoying these "new" phones.
Just for the intrested, I haev Kramer modded and wuarter modded these.


-greg




I am gonig to get a newset of foam pads and hope that that takes care of the prob.

