Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Post your ksc-75 mods here
New Posts  All Forums:Forum Nav:

Post your ksc-75 mods here - Page 2

post #16 of 18
5/10/06 at 1:43am
Check Signature
Reply

Head-Fi's Best Sellers

post #17 of 18
3/4/13 at 11:36pm
Quote:


Used a pair of cheap Coby foldables ($3 at the drugstore) for the headband. After I ripped out their drivers, there was a little cup left to fit in the Koss brackets. Obviously, I had to chop them off of the earclips which was a bit tough with just an exacto. Again, secured with hot glue (tons this time ). After that, you can just pop the drivers in like regular clips.

 

Do you know if all cheap headphones in the sub10 dollar range will have these hinges inside the housing?

Reply
post #18 of 18
3/5/13 at 1:12am
Quote:
Originally Posted by Goit View Post

Do you know if all cheap headphones in the sub10 dollar range will have these hinges inside the housing?

http://www.parts-express.com/pe/showdetl.cfm?partnumber=240-015

 

^ The original "KSC75 headband mod" headband source. Just scroll down to read all those comments lol.

 

You could probably find it on amazon / ebay instead of the parts-express site too, if buying from there is inconvenient.


Edited by jerg - 3/5/13 at 1:13am
Reply
New Posts  All Forums:Forum Nav:
  Return Home

Head-Fi's Best Sellers

Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › Post your ksc-75 mods here