Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › mounting boards in metal cases, Question!
New Posts  All Forums:Forum Nav:

mounting boards in metal cases, Question!

post #1 of 8
3/16/06 at 5:29pm
Thread Starter 
what's the best way to mount a pcb in a metal case so that there is no risk of the bottom leads touching the case?

(pimeta in a hammond)
Reply

Head-Fi's Best Sellers

post #2 of 8
3/16/06 at 5:34pm
Use PCB standoffs (these typically come in nylon or aluminum) and insulate the bottom of the case with electrical tape or something if necessary.
Reply
post #3 of 8
3/16/06 at 5:39pm
Thread Starter 
if it has to be as close to the bottom as possible, any other suggestions?
Reply
post #4 of 8
3/16/06 at 5:44pm
Insulate with electrical tape or a teflon sheet or something.
Reply
post #5 of 8
3/16/06 at 5:50pm
Thread Starter 
thats what i was thinking. thanks for your input.
Reply
post #6 of 8
3/16/06 at 6:00pm
for the real deal commercial grade solution try fish paper.Cheap,high breakdown voltage,easier to use than most solutions and in fact is probably in a lot of you consumer gear and you don't even know it


EDIT


oopsy !

sent you to my secure page there

try this

www.tubesandmore.com and in the search type in "fish paper then click for the separate page of details
Reply
post #7 of 8
3/16/06 at 8:18pm
High voltage electrical tape that is fairly thick.. make sure you dont have any sharp points on the bottom of the board that may make their way thought the protection.

That fish paper looks cool.
Reply
post #8 of 8
3/16/06 at 9:22pm
Well if you use the Alps BLue velvet pot or even one of the cheaper ones
you can use them to secure the panel. They provide a real good grip. IMHO there is no need to use extra mounting hardware unless you're not board mounting the pot.
Reply
New Posts  All Forums:Forum Nav:
  Return Home

Head-Fi's Best Sellers

Head-Fi.org › Forums › Misc.-Category Forums › DIY (Do-It-Yourself) Discussions › mounting boards in metal cases, Question!