__________________
dedicated headphone system
source: sony cdpx3000es (soon to be used as transport)
cable: nordost flatline blue heaven
Amp: earmax pro
headphones: hd565 ovation
hd 650
I thought that Cardas had stopped making the smurf cable and that all you could get now was the gray jacketed stuff?
Everytime I order it I end up with the blue, maybe the suppliers have tons of old stock that they are sitting on. I'm sure that most normal people would prefer the gray. I'd personally be happy with some bright glossy orange or purple.... George Cardas I hope you're listening
__________________ Cans: AH-D2000 ◦ K240S ◦ DT990 '05 ◦ MS-1 ◦ MS-2i Amps:Little Dot II ◦ Pimeta ◦ Rockhopper M3 ◦ WooAudio3 Sources: Ack dAck 1.3 ◦ PCD-300A ◦ S-100 mkII ◦ X-DAC v3 ◦ Xpression III + VP129 Portables: iRiver iMP-550 ◦ Microsoft Zune ◦ 1G Shuffle ◦ Sony D-EJ2000 Speakers: NHT Classic Three Bookshelves ◦ RC Line Arrays + Newform Ribbons My Feedback ● Team Cable DIY ● The Anime Thread ● The Video Game Thread
I would just like to say that I've spent the last hour drooling over the cables in this thread. I'm brand new to this, my background being in photography, so I have almost zero familiarity with this sort of thing, but the quality of the cables (and amps and etc etc etc) that you guys build is quite apparent and very impressive. Excellent stuff.
__________________
Enthusiastic newcomer
Roland RH-D20 'phones
JDS Labs cMoy
8GB nano
(And lots of ideas)
I tried to re-cable my Koss KSC75 just to find out that the entire housing is in fact the drivers! So I broke them by removing the chip like part inside the where the clip goes. So I tried to open them further and well you know the rest! ;P
__________________
:DI like it when things go !BOOM!:D
I tried to re-cable my Koss KSC75 just to find out that the entire housing is in fact the drivers! So I broke them by removing the chip like part inside the where the clip goes. So I tried to open them further and well you know the rest! ;P
Once you pull off the ear clips, that little dark gray plastic piece lifts off to give you access to the soldering terminals. Should only take a few seconds to get to to that point if you're doing it right. Don't hold me responsible if you pwn another pair though
__________________ Cans: AH-D2000 ◦ K240S ◦ DT990 '05 ◦ MS-1 ◦ MS-2i Amps:Little Dot II ◦ Pimeta ◦ Rockhopper M3 ◦ WooAudio3 Sources: Ack dAck 1.3 ◦ PCD-300A ◦ S-100 mkII ◦ X-DAC v3 ◦ Xpression III + VP129 Portables: iRiver iMP-550 ◦ Microsoft Zune ◦ 1G Shuffle ◦ Sony D-EJ2000 Speakers: NHT Classic Three Bookshelves ◦ RC Line Arrays + Newform Ribbons My Feedback ● Team Cable DIY ● The Anime Thread ● The Video Game Thread
Linear Mode
