Support Head-Fi.org by
starting all of your
Amazon.com shopping by
clicking here.
____________________________________________________________________
Today's Featured Head-Fi Blog: Jude's Blog
____________________________________________________________________
Please help
support Head-Fi by becoming a Contributing Member
CLICK
HERE -- Contributing Members, thank you
for your generous support! --
The Positive (long leg) would go to the source (ipod), whilst the other straight to the output.
iQEM: The BG NXs are non-polar just as KoKo mentioned, so it really wouldn't matter which way you put it (even though there is a long/short leg.. it doesn't matter..).
iQEM, the capacitor you are using is non-polar. No + or -. Work either way. (I 99% suppose)
Originally Posted by ruZZ.il
The Positive (long leg) would go to the source (ipod), whilst the other straight to the output.
iQEM: The BG NXs are non-polar just as KoKo mentioned, so it really wouldn't matter which way you put it (even though there is a long/short leg.. it doesn't matter..).
thx for the input tips guys, now i'll make the dock connector with caps inside right away... now what pin should i use on the dock connector to put the caps ?
25 Line In - Left
26 Line In - Right
27 Line Out - Left
28 Line Out - Right
Pins 1 and 2 are the same, so you can use either one. I would go with pin 1 because it's farther away from pins 3 and 4, your audio pins. This way it's just that extra bit safer.
Good point! I've always used 2 for some odd reason
i wanna make it like in this pict:
Credit by warrior05
it's look like it use 27 and 28 ? am i wrong ?
Yes, you are wrong You can tell by the grooves in the dock connector by looking at it, it should be facing down (pin 1 is on the far left when facing down)...so the pins that are used are pins 1 or 2 for ground, 3 for right, and 4 for left! 27 and 28 you dont need to worry about!
3 & 4 ? damn, that's was close...but after i figure out i broken the dock connector (an $5 charger, what a waste ), now what should i do ? any other alternative ? like using headphone out route ?
3 & 4 ? damn, that's was close...but after i figure out i broken the dock connector (an $5 charger, what a waste ), now what should i do ? any other alternative ? like using headphone out route ?
What did you do to the connector? you can replace pins in them if thats the problem. Just pull out the damaged ones and pull out a good one and slide it into the desired pin slot to replace. It might take a few trys but you have lots of pins you won't use.
__________________
Headphones : HD650, D2000
Amps : Millet Max
Source: Oppo 980, iMod, Clip, PC/ emu 0404 USB
Builds ongoing: Bijou, Soha/jisbos
Came and Went : SR80, HD 25-1 II, SR325i, cmoys, HeadFive, GoVibev5, TotalAirhead, Denon D1000, CK2III, Shure e2c, iPod Video 80G, Cowon A3, LD II, ATH-A900LTD, HD580, Millet Max, DT770's
now what pin should i use on the dock connector to put the caps ?
), now what should i do ? any other alternative ? like using headphone out route ? 