- DIY Project: TPA6120//CS3310 Headphone AMP- Remote controled
- Any opinions on this tubed DAC kit?
- PCB extension leads
- AMB M3 capacitor coupling question
- Like a tank, a frickin' tank
- wire for RCA-1/4'
- Running out of time!: Wires
- Help regarding premium clock upgrades.
- ESS Sabre DAC chip info search...
- Need someone to modify a Millet Hybrid for me
- Balanced solid state amp options
- a unrelated question
- washing headphone pads?
- Any ideas to solve turn-off transients with my M3?
- Project: M³ home studio speaker amp
- Can someone reterminate my IEMs?
- My DIY Fullrange Speakers
- Good Piece to build a Zune LOD?
- WHY can't I buy nylon multifilament anywhere using PayPal?
- Removing Hair from DT-770 Driver - It's Sticky??? (picture)
- A nice(?), simple chip amplifier
- Using interconnect wire for headphone recable?
- Where could i source feet and knobs?
- Can the e27 board be used on the M3 bass boost?
- Switch Box Grounding Scheme and Switch Selection
- Will virtual grounds screw my idea?
- 10w Speakers for Tube Radio?
- one 48inch 1080i monitor VS two 22 in LCD's LATENCY/BEST for audio
- Wire gauge for interconnects?
- My newest cable creation... what do you think? (56K)
- Balancing HD600
- Jack connector for B22
- DIY Amp choosing
- Aikido valve ampbuilders, please respond
- Solder suggestions for fixing headphones
- Weller WLC100 in Australia.
- Transformer for tripath Amp
- Balanced M3
- Connector isolation for metal panel
- WTD: Balanced B22 Amp [UK]
- Custom IEM Cable ! Help required
- KGBH - Searching for a BOM
- Advice on wooden cups
- Mini^3 acting up, need advice.
- To Tube or Not To Tube
- Please help! Getting bad shorting out sound
- Wire Size (AWG) for DIY LOD
- Help charging two 9volt batteries
- removing heatshrink?
- small form factor 100k or 50k pot
- E-mu 0404 usb main output potentiometer part?
- Grado SR-80 Repair Help Needed (Looking for EU DIYer too).
- Replacing entire headphone cable
- Making my first cable
- Mogami Neglex -vs- Stock HD 650 Cable?
- Vias on SMT pads
- How do YOU cut a square hole into AL?
- Jena Labs braiding tutorial?
- what signals does a usb-dac need?
- Four conductor power connectors?
- capacitor code
- Which wire for diyMod?
- hard to find tubes and expensive parts
- Question about PPA v2 and YJPS resistors
- What wire does you choose for you DIY ?
- Best rechargeable batteries?
- Wire selection for first projects
- Vampire stranded cast copper wire VS Vampire single strand magnet wire
- Simaudio integrated burned out, what should I do with parts?
- CMOY tweaks for low impedence cans...
- Where to buy CS4397 chip on 24pol adapter?
- laptop powersuply for cmoy?
- AKG K1000 Selector
- Recabling M50's, Need help, First time.
- Help finding CA1458 replacement
- mini xlr questions
- Guide to ReCable (Dual Entry) BeyerDynamic DT (with pictures!)
- Source for 10k stereo mini-potentiometer?
- Next step amplifier/DAC
- iPod video modding (help plz?)
- e12 and heatsinks for Q1 & Q2 requirement
- Dark Voice 332 Schematic
- Unbalanced inputs for balanced output?
- Online DIY stores that will take Paypal?
- KGSS 110 to 220V?
- Diy Dac what should i go for?
- Why is SRPP not suitable for driving capacitive loads (such as ES phones)
- mini3 performance or runtime?
- Need Help With Unussual Project
- What to do with old car speakers?
- First try at DIY speakers. (total noob)
- Two conductor cable for tonearm rewire
- XLR's - Split from iPodPJ's B22 thread
- Transformers for Balanced to SE conversion.
- Request for interconnect
- DIY tubes
- Balance amp wiring question
- Zero DAC schematic
- Voltage regulator advice
- Proper technique for soldering cardas sennheiser plug?
- This is fun!
- Phase shift in the feedback stage of an amplifier
- Where can I buy ViaBlue and Furutech 1/4 mono connectors?
- Recable with John's Silver Teflon Wire
- AMB (Ti Kan) Appreciation Thread
- My grado sr125 mods.
- Amp for HD650's
- Silly Question
- Started tool kit
- Help - What did I fry?
- Power Supply Questions: Sigma 11 or 22?
- Iphone Line-in dock
- DIY Sennheiser HD800 balanced cable
- tried a little expieriment..... WOW
- General equipment question
- Aluminum case with heatsink
- Are these appropriate materials for DIY headphone cable?
- Total Bithead repair
- Proposely to make a sticky for Knobs
- PCB fab house recommendations
- Questions on MOSFET followers.
- Extending a volume knob?
- Looking for and wondering...
- Runtime for Mini3 Editions
- DC power connector for 24V?
- Starving Student???
- What is the purpose of adding capacitors?
- For a first time DIYer, CMOY or Mini3 V2?
- Glass Jar Audio - Do they have high quality kit parts?
- DIY Amp Prob - Help?
- The hunt for a good High Voltage output cap
- My first headpones, thanks Head-Fi!
- Grado sr-80 mod idea.
- New MiniMax, No Dice
- Good cable for making short interconnects?
- $15 soldering iron worth even trying?
- Odd request: Single side, mono headphone help
- recabling question NOOB
- very weird mini3 problem
- cmoybb 2.02 help
- LSK389 - the KGSS is buildable again!
- Need advice for soldering-iron.
- PURPLE cable suitable for guitar cable?
- HiFi2000 Machining?
- Building IPOD LOD- recomendations for what wire to use?
- Simple Stereo Preamp
- Simple 2-way switcher-selector on relay.
- Is it worth it to modify/hotrod vintage cans?
- Project Cans- Recommend some mods
- Affordable retro wood covers for your next amp project
- Denoise a switching power supply
- netbook (acer aspire one) hacks?
- Wanted: bag 'o junk
- sennheiser lucas pinouts?
- Cable info
- Vintage SR325 cable questions.
- ß22 + σ22 design complete ••• Opinions welcome
- Bass Boost on the output
- Choosing a power connector + switch for the Sigma 11
- Solder flux paste?
- M3 supply rail Troubleshooting
- 1st Time DAC build, need help.
- Strain relief won't fit on plug
- How right highlight tubes?
- DIY PDA
- Make a VERY simple DAC?
- Best 1\4" HP Jack?
- Mini^3 DIY Tips
- Alternative N Channel JFETs for LTPs
- Balanced Mid-Fi? Developing a JISBOS-with-gain Balanced Preamp./Headphone Amplifier
- DIY USB cable
- Normalled Balanced Headphone Output Options?
- Urgent: Ultrasone HFI-650
- headphone amp design w/ true headphone OPT
- AD 8066 problems
- Paint Touch-Up
- Ipod speaker
- Looking for a decent 50k pot for M3
- DACT vs Joshua Tree Attenuator??
- Cable strengthening? Cablesocks/tights?
- Installing IEC Socket
- LM47920HA in a CMoy
- Asking for advice!
- Volume Control between amp and headphones
- Stick with TRS? recable time
- Project: Audiophile Media 'Brick'
- M3 gain recommendations
- how to convert mod to wmv/avi/mp4/mov/mpg for Mac/Windows
- Denon Receiver Fuse Question
- CKKIII Parts list
- Best <$5 1/4" 2 conductor TRS plug for DIY cables.
- ~$20 DIY mono 1/4" TRS to mono RCA DIY Pair
- Want to build inline volume control
- DIYing guitar cables, any tips?
- Furutech fp-704 seek solder help
- Any DIY supply sites that won't kick my ass on shipping?
- Tube buffer for V-out DAC's
- Fixing and Recasing an MPX3?
- LME 49600 as output buffer help
- where to buy Manufaktur-like genuine leather?
- miniMax alternate DC jack?
- How to convert DVD to iPod/iPhone/Sansa/PSP/Zune/iRiver/Google Phone/Cell Phone, etc. on Mac
- Switch signal to power amp before or after JISBOS Buffer?
- Are DIY CD or SACD players possible?
- The M4: A fully differential, single-PCB amplifier with relay attenuator
- mini 3 vs pimeta v2
- Higher end portable amps
- brick and mortar store in bay area which sells audio connectors
- what's 4-channel technology?
- Drill and Drill Bits
- Burning Amp Festival - October 18, 2009
- new frankenphones pic
- Stepped Attenuator Tactile Feel
- 5th Gen iPod Video Logic Board Differences?
- Dual CMOY Amplifier Idea, will it work?
- Small circuit board holders
- Westone Connectors
- Audio Technica ATH-ESW9 Recable Step-by-Step w/ Pics
- Grado Headband Mod
- Need help choosing a rotary switch from Mauser's website
- Low-Profile 3.5mm headphone jack
- Buying DIY supplies
- headphone jack problem
- XLR Out into 2x RCA signal?
- Headphone jack extender
- Curious about 3 channel amps...
- An hybrid headphones amp... the other way around
- A few questions regarding magnifier lamps
- Newb power supply questions
- Four pin XLR "standard"
- Pimeta V1 opamps - For higher impedance cans
- New Meter for my DIY Toolbox
- Eagle libary for alps poti
- Looking for bases of 6SN7 tubes
- Building an RCA switch box
- Need help on a YAHA build.
- Essential work tools?
- Questions about wiring
- 3.5mm disaster
- can anyone help with a supplier in the uk or ebay for mogami cable suitable for headphone cable replacement
- eXStata DIY Electrostatic Amp for Intermediate DIYers
- Impedance Up/down converter
- YARAAP
- Looking for good build project
- The Counterpoint I/V analog stage
- Any good bay area DIYERS.. Need some assistance.
- NOBLE (dangit) pot wiring
- Portable Tube amp by Oatley: K272
- More oscilloscope questions
- how to convert mod to wmv/avi/mp4/mov/mpg for Mac/Windows