This is closest to the DIY section, so I will have to post it here. I was replacing my broken TOSLINK connector the other day, and I think there was a bridged connection. The mosfet in the left rear closest to the power plug got very hot to the touch, and the LEDs in the front panel were not lit. I cut the bridge, and the LEDs came back. Now when I plug in the TOSLINK or the digital coax, the signal LED on the board does not light, and I am not hearing the click I usually get when the board senses a digital signal. Anyone have any idea what might have fried? I did not see any sparks, and there wasn't a short as far as I know. Everything seems to power up fine, except for the digital input.
|