Quote:
Originally Posted by tangent
There will be at least one more prototype run of this board, so now's the time to make requests.
|
I believe that I mentioned this way back when I gave you my build notes but have you ruled out a Vout trimpot simliar to the STEPS design? Personally, I have no issue with the resistor setup the way that it is on the current pcb but the tweakers out there might not be happy until they can dial in exactly 24V out (or whatever).
One more thing for rds: watch out for the on board fuse location. I found that the spacing of the mounting points was a bit too close for the typical fuses. It might be easier to just use an off-board fuse if you have the same version pcb that I had. I know tangent was going to address it in future versions.