New Posts All Forums:Forum Nav:

DIY (Do-It-Yourself) Discussions - Page 43

Subscribe RSS Search This Forum

Forum

Last Post

Threads

Posts

The DIY Big List & Rules Section

(1 Viewing)

DIY link thread

5/2/11 at 3:55pm by Assimilator702

Start a New Thread

Thread	Last Post	Replies	Views
PIMETA v2 and occasional 'click' noise started by christsay (10/10/10 at 11:40am)	From what I can see, it looks okay. The main thing I can't... 10/11/10 at 11:58pm by tangent	6	285
Eagle PCB design opinions (non-audio related) started by bmwpowere36m3 (9/29/10 at 7:14pm)	An improvement, though I can't imagine C1 can pass DRC like... 10/11/10 at 11:21pm by Nemo de Monet	13	589
CD3000 recable Question started by ivanrocks321 (10/11/10 at 5:25pm)	that should shed some lights, it's very easy to disassemble: 10/11/10 at 10:49pm by leeperry	1	113
Looking for DIYer for possible M^3 build. started by matthewh133 (10/11/10 at 8:58pm)	Hello DIYers I am contemplating picking up an M^3 for my... 10/11/10 at 8:58pm by matthewh133	0	140
Yuin PK1 - Cannot Solder Plug! started by jcw122 (10/6/10 at 4:30pm) 1 2	there's some pics here actually. sounds like a plan! 10/11/10 at 4:05pm by leeperry	23	731
What's so bad about Generic, No-Name(Radioshack, et al) Connectors? started by dxps26 (9/28/10 at 9:44pm)	Ease of assembly does not equal quality. Out of curiosity,... 10/11/10 at 2:49pm by samsquanch	12	617
Next Project suggestions started by FishHead (10/5/10 at 5:45am)	I did have some ringing with a set of tubes but I switched... 10/11/10 at 10:37am by FishHead	6	319
Configuration to Prevent Ground Loop for DIY IC started by XTTX (10/6/10 at 10:43pm)	What measurements specifically would you take? Also, I have... 10/11/10 at 5:42am by XTTX	3	211
Mounting LED's started by stringgz301 (10/9/10 at 11:08am)	The last two I did were just holes, but, the board was close... 10/11/10 at 4:28am by jdkJake	6	304
is there a tube equivalent to the cmoy? started by Soymilk (10/7/10 at 3:08pm) 1 2	MEHA might be an idea too http://www.ecp.cc/meha.html 10/11/10 at 12:53am by burgunder	27	1,959
diy equalizer? how? started by ruijorgemoreno (10/9/10 at 12:16pm)	Keep in mind that if you want this, the relevant factor is... 10/10/10 at 6:45pm by gimble	5	415
Could I build a VU meter for my mono tube amp from these meters? (pics included) started by chadbang (10/10/10 at 2:17pm)	You could just use a simple resistor divider to make them... 10/10/10 at 3:05pm by Avro_Arrow	1	319
HD595 drivers in HD590 body started by ris3nda3mon (10/10/10 at 2:27pm)	So I have a pair of 590’s in which the right driver has... 10/10/10 at 2:27pm by ris3nda3mon	0	140
. started by BobSaysHi (10/10/10 at 12:21pm)	. 10/10/10 at 12:21pm by BobSaysHi	0	546
Need help from Experienced Eyes: Toshiba 2SC2238/2SA968 Parts -- Do these look genuine? started by jdkJake (10/4/10 at 5:15pm) 1 2	Sage advice TomB. And I respect it as such. This has become... 10/9/10 at 5:57pm by jdkJake	16	998
Problem with TPA Buffalo 24 DAC after wiring started by tranhieu (10/7/10 at 4:51pm)	Wrong wiring~ make sure you use at least more than 2... 10/9/10 at 5:08pm by tranhieu	3	167
What is the lifespan of an output MOSFET? started by Mellow Mushroom (12/21/08 at 3:32am)	As long as they are not abused MOSFETs can last almost... 10/9/10 at 2:28pm by amb	6	469
What is your flux routine? started by ROBSCIX (10/8/10 at 7:22am)	that fine organic flux cored kester solder you use has quite... 10/9/10 at 8:38am by qusp	9	337
CMOY build problem. Voltage swings when op-amp plugged in - poor sound. NOOB build - help please! started by bgpaladin (10/6/10 at 8:06pm)	I tried the TL2426 and it fixed the problem - perfect voltage... 10/8/10 at 5:41pm by bgpaladin	5	393
Amp to drive speakers started by Speedmax (10/5/10 at 6:02pm) 1 2	Is the volume on the MP3 player turned all the way up? Try it... 10/8/10 at 1:34pm by nikongod	20	806
Help with wire fixing... started by yeky83 (10/6/10 at 7:47pm)	If you are going to replace the "Y" splitter while it's off,... 10/7/10 at 5:42pm by Fred_fred2004	1	163
Minimax Build Problem - No Sound/Signal started by tehsn1p3r (9/26/10 at 11:07am)	I agree with jdkjake, but you need to tell us what you mean... 10/7/10 at 5:08pm by tomb	6	241
DIY Power cable - Heat Shrink Sizing question started by everettjsj2 (3/13/10 at 3:54pm)	Great thread and points here. A little older thread but I... 10/6/10 at 11:15am by briansparks0211	5	574
Tutorial: How to make a Zen V:M LOD (with pictures) started by wgr73 (6/28/07 at 12:45am) 1 2 3 4	Thanks guys!! I appreciate the feedback! 10/6/10 at 8:32am by wgr73	54	8,775
Various questions about Cmoy headphones amplifier started by Rullknufs (9/30/10 at 7:48am)	ah. that sucks 10/6/10 at 12:41am by Soymilk	7	422
Community Help: DIY: Electrostatic Speakers started by xthakila (9/30/10 at 8:06pm) 1 2	Lol never mind I have finally got all the parts on order.... 10/5/10 at 7:12pm by xthakila	17	949
diymod cable problems with ground hum started by knalb (10/4/10 at 9:08am)	Easy solutions are always the best!! 10/5/10 at 3:40am by MrTom	5	206
distortion from DAC-AH after passive and battery mods started by siava1018 (10/4/10 at 1:30pm)	ok i played with the trim pot and now have it set to 4.55v... 10/4/10 at 2:37pm by siava1018	1	109
It's a question of gain... started by Avro_Arrow (10/2/10 at 12:34pm)	Did you volume match? Set 1 amp to your preferred level by... 10/4/10 at 8:00am by nikongod	11	375
The War Against Headphone Hair started by Ikarios (9/26/10 at 10:30pm)	Yes, this is good thread but I think we can't do much. It's... 10/4/10 at 7:17am by akgfan	5	508
HJE900 recable possible? started by Libertad (1/11/09 at 2:16am)	Found this. Might help a little.... 10/4/10 at 5:36am by customNuts	3	549
Replacing a Sennheiser HD 280 Pro cable started by MobsterOO7 (8/30/09 at 11:06am)	HHopefully this thread is still active... I have a 280 pro... 10/4/10 at 12:37am by reginaldnugroho	9	883
Senn HD 280 recable? started by alwayshungry (6/23/08 at 4:25am)	Hi alwayshungry... Sorry for opening up a 2 year old... 10/4/10 at 12:25am by reginaldnugroho	3	416
Weird hiss with pcm2702 started by 00940 (10/3/10 at 3:58pm)	I'm wondering if anyone has encountered the same issue : ... 10/3/10 at 3:58pm by 00940	0	129
Tube movement makes crackling sound started by PointyFox (10/3/10 at 1:55am)	It's not microphonics, also, I can't access the socket contacts. 10/3/10 at 12:44pm by PointyFox	2	180
power-on circuitry? also couple cmoy questions started by Soymilk (9/8/10 at 12:52pm) 1 2	There is some formulas on this page that may help: RC Time... 10/3/10 at 5:20am by cobaltmute	25	769
anyone else feel kind of dirty looking at this? started by Soymilk (9/30/10 at 2:44pm) 1 2	shut up it was taken with my phone, i cant choose what it... 10/3/10 at 4:01am by Soymilk	18	1,270
best DIY headphone cable for Ultrasone DJ1 Pro? started by nlse (10/2/10 at 8:00pm)	Very easy. Ultrasone uses a simple 3.5mm plug to connect the... 10/3/10 at 1:59am by apatN	1	504
Necessary to braid headphone wires that will later be sleeved together? started by jbsteeves (9/30/10 at 7:11am)	braiding isnt to keep the wires together..... tough it does... 10/3/10 at 12:12am by qusp	3	777
AC/DC Coupling questions cmoybb started by Lucias_D (9/21/10 at 5:11pm)	Yeah, I tried that, but only after I tried scraping it a... 10/2/10 at 5:50pm by Lucias_D	9	830
Mini3 & Gamma 1: Missorder of parts started by KnightOfAwesome (9/30/10 at 10:34pm)	I recently placed my first orders with Mouser and Digi-Key -... 10/2/10 at 5:43pm by BK_856er	3	278
Let's build Krmathis a Beta22! started by amphead (7/14/08 at 7:19am) 1 2 3…40	Great amp! K1000's rule 10/2/10 at 4:15pm by amphead	589	66,438
Need some help finding a replacement potentiometer for an older piece of equipment started by HiGHFLYiN9 (9/26/10 at 12:27pm)	It's solid state, but I really liked the looks of it, so I... 10/2/10 at 11:31am by HiGHFLYiN9	6	245
Beginner wondering how hard it is to put together a GrubDAC and MiniMAX started by iLol (8/3/10 at 5:02am)	You're talking about a MOSFET-MAX, which is made with the new... 10/2/10 at 5:00am by tomb	9	647
Amp design question started by shake (9/17/10 at 5:34pm) 1 2 3…6	I switched the OUT and COM pins on the TLE... made a funny... 10/2/10 at 12:37am by shake	83	2,796
DIY HD650 Silver/Blue Dragon Cable? started by matthewh133 (9/28/10 at 6:26am)	Thanks again 10/1/10 at 11:45pm by matthewh133	8	754
B22 Price and other questions started by Arlekiin (10/1/10 at 4:18am) 1 2	The BOM is only for one board without power supply. It also... 10/1/10 at 6:20pm by cobaltmute	18	967
"Unloaded" Headphone Driver Enclosures started by Skoobs (9/26/10 at 1:43am)	Depending on the size you could go with AKG pads (K240/K271).... 10/1/10 at 5:46pm by TheKisho	5	315
Best Wire for IEMs started by XTTX (9/29/10 at 4:46pm)	Making IEM cables from scratch is far from the easiest way to... 10/1/10 at 3:30pm by limpidglitch	6	711
Quick Transformer Current Output Question. (Volt Amp = ?) started by TheLaw (9/30/10 at 5:27pm)	Thanks! 10/1/10 at 1:56pm by TheLaw	2	202

Start a New Thread

Subscribe RSS Search This Forum

New Posts All Forums:Forum Nav:

DIY (Do-It-Yourself) Discussions - Page 43

The DIY Big List & Rules Section

Recent Discussions

Recent Reviews

Recent Articles

Featured Sponsors

Sponsor Showcases

DIY (Do-It-Yourself) Discussions - Page 43

The DIY Big List & Rules Section

Recent Discussions

Recent Reviews

Recent Articles